Highlights

• Max Output Power of 900 Watts RMS, 4x 225 Watts at 2 Ohms- 4 Channel full range amplifier stable at 2 Ohms each gives you the benefit to wire multiple speakers and dividing the power.
• Ultra Compact Design, where performance is not sacrificed! Dimensions: 9″ Wide x 7.28″ Length x 2.15″ Height
• 4 Gauge power/ground connectors and 12 Gauge speaker terminals
• Built-in variable HPF / LPF crossover filters and bass boost control. This allows tuning for speakers or horn drivers, an easy setup without needing an external crossover.

Our engineering team focused on achieving fidelity first, and then on making our Q Series amplifiers amazingly efficient and small.

The Q800.4 2 Ohms is rated at 4x 200 Watts RMS at 12.6 volts with 88% efficiency.

• BRIDGEABLE: Double the power output to your speakers by bridging two channels. Minimum impedance of 4 Ohms per bridged channel at output power of 2 x 400 Watts RMS

The Q Series delivers the most innovative nano technology, able to constantly deliver power at a wide frequency range when on a compact heatsink. Loaded with features, built-In Low/ High Pass Filter, Bass Boost allow the use of this amplifier for a broader variety of applications – from deep bass all the way to high frequencies.

Before Installing:

You must follow the instructions for the product’s installation to guarantee optimal performance. If you have any questions, get in touch with us. Before using the amplifier, always follow these guidelines:

• Make sure the amplifier is switched off before adding or removing any connections. This prevents possible damage to equipment.
• Keep all cables as far away as possible from the ignition cables, electronic injection modules and starter switch since they may cause noise interference;
• Always use 100% Copper wire and good quality connectors. This guarantees reliability and performance.
• To avoid damaging the cables, make sure that they do not touch sharp metal edges. Important: For this amp use a 60A fuse 12 inches away from the battery as a safety precaution

_{The power rating data is based on equipment from the PRV Audio Group laboratory. Rated power tested with 100Hz to 1KHz sinusoidal signal and THD <= 1%, with resistant load referring to the indicated measurements. The electronic components and the manufacturing process can present manufacturing variations, thus leading to a variation in the measurements made. This amplifier is designed to perform on music applications ( with speakers ), any load test ( resistant  load ) is not recommended.}